SHUNT​
Product Details
The shunts are designed & manufactured to comply with the requirements of IS1248 / DIN43703 & DIN43780. The shunt provides an accurate d .c. millivolt signal, exactly proportional to the measuring current.
Features
- Rating 1A to 15000A
- Riveted and soldered construction
- In-line bus bar mounting
- Very low temperature coefficient
- High overload withstand
- Shock and vibration tested
- Long term stability
Installation
The best performance is guaranteed if the following points are observed.
- 1) Shunts may be mounted horizontally or vertically. Horizontal mounting gives the best heat dissipation.
- 2) Utilize the full end block surface area.
- 3) Ample ventilation should be p rovided.
- 4) Busbar should be adequately rated, cleaned & coated with a thin layer of silicon grease between the contact surfaces.
- 5) Bolts and nuts must be carefully tightened.
Caution :Shunts are not insulated & protection against accidental contact may be necessary in order to comply with Health & Safety regulations.